Siemens SIMATIC ET 200eco PN - Maintenance interrupts

Interrupt, error, and system messages
7.2 Maintenance interrupts
ET 200eco PN
84 Operating Instructions, 08/2016, A5E01250250-AJ
7.2
Maintenance interrupts
Introduction
The PROFINET interfaces of the ET 200eco PN support the diagnostics concept and
maintenance concept in PROFINET as defined in IEC 61158-6-10. The objective is early
detection and elimination of potential disturbances.
Maintenance interrupts
The following maintenance interrupts are available for the ET 200eco PN:
● Sync mismatch (no synchronization)
● Jitter out of Boundary (jitter too high)
● Frame dropped (frames are discarded)
● I/O error (with IO-Link devices)
System alarms in STEP 7
The maintenance information is generated in STEP 7 with the following system alarms:
● Maintenance required, identified by a yellow wrench icon at the relevant port.
See also
For additional information, refer to the SIMATIC PROFINET system description
(http://support.automation.siemens.com/WW/view/en/19292127
) System Manual and the
Migration from PROFIBUS DP to PROFINET IO
(
http://support.automation.siemens.com/WW/view/en/19289930) Programming Manual.