Siemens SIMATIC ET 200eco PN - Installing the terminal block

Installing
2.4 Installing the terminal block
ET 200eco PN
Operating Instructions, 08/2016, A5E01250250-AJ
25
2.4
Installing the terminal block
Properties
The terminal block connects the ET 200eco PN and supplies the I/O device with power.
The terminal block
● can be installed separately,
● or be screwed on to each I/O device.
Requirements
Note that you must wire the terminal block before you install it.
Tools required
Recessed head screwdriver, medium size
Installing the terminal block separately
You install the terminal block separately.
Remove the screws and then screw them in again at the bottom of the housing.
Figure 2-5 Installing the terminal block separately