ET 200eco PN
20 Operating Instructions, 08/2016, A5E01250250-AJ
Two installation variants
There are two installation variants:
● With mounting rail
● Without mounting rail
For corresponding conditions, refer to the next chapters.
Installation without mounting rail
Simple installation
The ET 200eco PN distributed I/O device is designed for easy installation.
● The I/O device must be mounted on a solid base
● and can be prewired.
Cylinder head screw M5 to ISO 1207/ISO 1580
Minimum screw length: 30 mm.
Any washers you might need should conform to
DIN 125.
Hexagon socket head cap screws M5 to
Medium-sized screwdriver or 4 mm hex socket driver.
To Next Page
Loading...
