Siemens SIMATIC ET 200eco PN - Removing ET 200 eco PN

Installing
2.6 Removing ET 200eco PN
ET 200eco PN
28 Operating Instructions, 08/2016, A5E01250250-AJ
2.6
Removing ET 200eco PN
Procedure
The ET 200eco PN is wired up and operating.
1. Switch off the supply voltage to the ET 200eco PN.
2. Disconnect the wiring from the I/O device.
3. Remove the fixing screws from the I/O device.
Note
Observe the information in chapt
er Looping PROFINET and the supply voltage (Page 66
)
when replacing the I/O device.