Siemens SIMATIC ET 200eco PN - Ports of ET 200 eco PN

Configuring
4.4 Ports of ET 200eco PN
ET 200eco PN
72 Operating Instructions, 08/2016, A5E01250250-AJ
4.4
Ports of ET 200eco PN
Introduction
The ET 200eco PN can diagnose 2 ports: X01 P1 and X01 P2.
Requirements
● The ports must have been configured in HW Config .
● Port diagnostics must have been enabled.
Configuring the ports in HW Config
Configure both ports in the "Properties of ET 200eco PN" dialog box of HW Config:
● "Addresses" tab: Diagnostic address of the relevant port.
● "Topology" tab:
● "Options" tab:
To enable port diagnostics, select the following "Connection" setting at "Transmission
Medium/Duplex": "Automatic Settings (monitor)".
See also
See the STEP 7 Online Help.