Siemens SIMATIC ET 200eco PN - EMC compatibility, shipping and storage conditions

General technical data
8.2 EMC compatibility, shipping and storage conditions
ET 200eco PN
102 Operating Instructions, 08/2016, A5E01250250-AJ
8.2
EMC compatibility, shipping and storage conditions
Definition
Electromagnetic compatibility is the ability of an electrical device to function in its
electromagnetic environment in a satisfactory manner without affecting this environment.
The ET 200eco PN distributed I/O device also meets the requirements of the EMC law of the
European Single Market. Prerequisite is compliance of the electrical configuration of the
ET 200eco PN distributed I/O device with specifications and directives.
Pulse-shaped disturbances
The table below shows the electromagnetic compatibility of the ET 200eco PN distributed I/O
device with respect to pulse-shaped disturbances.
Pulse-shaped disturbance
Test voltage
corresponds with degree of
severity
Electrostatic discharge to
IEC 61000-4-2
8 kV
6 kV
3 (air discharge)
2 (contact discharge)
Burst pulses (high-speed transi-
ent disturbances) according to
IEC 61000-4-4.
2 kV (power supply line)
2 kV (signal line)
3
3
High-energy single pulse (surge) according to IEC 61000-4-5 *
3
• Asymmetric coupling
• Symmetric coupling
2 kV (power supply line)
2 kV (signal / data line)
1 kV (power supply line)
1 kV (signal / data line)
* On DC 24 V supply only with protective element
Sinusoidal disturbance variables
The table below shows the electromagnetic compatibility of the ET 200eco PN distributed I/O
device with respect to sinusoidal disturbances.
HF radiation according to IEC 61000-4-3
Electromagnetic HF field
HF coupling according to
IEC 61000-4-6
Amplitude modulated
80 to 1000 MHz; 1.4 to 2 GHz
0.15 MHz to 80 MHz
10 V/m 80% AM (1 kHz)
10 V
rms
unmodulated
2 to 2.7 GHz
80 % AM (1 kHz)
1 V/m at 80 % AM (1 kHz)
150 Ω source impedance