Siemens SIMATIC ET 200eco PN - Pin Assignment for Feeding and Looping the Voltage

Wiring
3.6 Pin assignment of connectors
ET 200eco PN
40 Operating Instructions, 08/2016, A5E01250250-AJ
3.6.2
Pin assignment for feeding and looping the voltage
Cable connector for supply voltage infeed, X03 connector
The table below lists the pin assignment for the supply voltage infeed.
Table 3- 2 Pin assignment of the M12 cable connector for the supply voltage infeed
Pin
Assignment
View of the cable connector
(wiring side)
1
Supply voltage 1L+ (non-switched)
2
Ground 2M (switched)
3
Ground 1M (non-switched)
4
Supply voltage 2L+ (switched)
5
Reserved
Cable connector for loop-through of the supply voltage, X02 socket
The following table lists the supply voltage for loop-through of the supply voltage.
Table 3- 3 Pin assignment of the M12 cable connector for loop-through of the voltage
Pin
Assignment
View of the cable connector
(wiring side)
1
Supply voltage 1L+ (non-switched)
2
Ground 2M (switched)
3
Ground 1M (non-switched)
4
Supply voltage 2L+ (switched)
5
Reserved
Note
The M12 sockets for the supply and I/O have the same coding.
Make sure that you wire the supply and the I/O correctly.