Siemens SIMATIC ET 200eco PN - Pin Assignment for Parameterizable Digital Input;Digital Output

Wiring
3.6 Pin assignment of connectors
ET 200eco PN
48 Operating Instructions, 08/2016, A5E01250250-AJ
When using the Y cable, pin 2 and pin 4 are assigned to pin 4 (B) and pin 4 (A).
Note
The M12 sockets for the supply and I/O have the same coding.
Make sure that you wire the supply and the I/O correctly.
3.6.5
Pin assignment for parameterizable digital input/digital output
I/O device 8 DIO DC 24V/1,3A 8×M12 (6ES7147-6BG00-0AB0)
You will find the pin assignment for the 8 DIO DC 24V/1,3A 8×M12 I/O device in the table
below.
Table 3- 11 Pin assignment of the M12 cable connector for the 8 DIO DC 24V/1,3A 8×M12 I/O de-
vice
Pin
Assignment
View of the cable connector (wiring
side)
Assignment X1 to X4 (1L+ non-switched)
Input
Output
1* 24 V sensor supply 1U
S
(derived from 1L+ non-switched)
2
Not used
3
Supply ground 1M
4 Input / output signal DIQ
0
: Connector X1
Input/output signal DIQ
1
: Connector X2
Input/output signal DIQ
2
: Connector X3
Input/output signal DIQ
3
: Connector X4
5
Functional earth FE
Assignment X5 to X8 (2L+ switched)
1 24 V sensor supply 2U
S
(derived from 2L+ switched)
2
Not used
3
Supply ground 2M
4 Input / output signal DIQ
4
: Connector X5
Input/output signal DIQ
5
: Connector X6
Input/output signal DIQ
6
: Connector X7
Input/output signal DIQ
7
: Connector X8
5 Functional earth FE
* The sensor supply is only available when the corresponding channel is parameterized as an "Input".