Siemens SIMATIC ET 200eco PN - Replacing labels

Installing
2.5 Replacing labels
ET 200eco PN
Operating Instructions, 08/2016, A5E01250250-AJ
27
2.5
Replacing labels
Properties
You can identify the I/O device and the I/O connectors using the labels. The module is
supplied with the labels already clipped into the holder.
● 1 for the I/O device
● 4 or 8 for the I/O connectors
Requirements
You can order replacement labels.
Tools required
2.5 to 4 mm slotted screwdriver
Replacing labels
1. Push the screwdriver into the small opening of the label at an angle and then lever it out.
Figure 2-7 Removing labels
2. Push the new label into the holder on the device.