Installing
2.4 Installing the terminal block
ET 200eco PN
26 Operating Instructions, 08/2016, A5E01250250-AJ
Installing the terminal block on an I/O device
Install the terminal block vertically on a housing of 30 mm width, or horizontally on a housing
of 60 mm width.
An M12 cap is attached to the bottom of the terminal block to implement the corresponding
degree of protection. Make sure that the M12 cap is not attached to the terminal block
connector and that it is mounted onto connector X02 of the I/O device. Bolt the terminal
block onto the I/O device by tightening the screws.
Figure 2-6 Installing the terminal block on an I/O device of 60 mm width
Terminal block (Page 229)
Wiring the terminal block (Page 59)
To Next Page
Loading...
