Siemens SIMATIC ET 200eco PN - Page 230

Terminal block and voltage distributor
12.1 Terminal block
ET 200eco PN
230 Operating Instructions, 08/2016, A5E01250250-AJ
Table 12- 2 Pin assignment of the M12 connector
Pin
Assignment
View of the cable connector
1
24 V (1L+ non-switched)
2 Ground 2M (switched)
3
Ground 1M (non-switched)
4 24 V (2L+ switched)
Block diagram
The block diagram below shows the terminal block.
Figure 12-1 Block diagram of the terminal block
Technical data
Dimensions and Weight
Dimensions W x H x D (mm)
30 x 50 x 98
Weight
Approx. 90 g
Current
Infeed current 1L+ and 2L+
Max. 10 A per 1L+ and 2L+
Output current via the M12 connector
Max. 4 A per 1L+ and 2L+
Power loss
Power loss of the terminal block 1 W, typical
See also
Installing the terminal block (Page 25)