Siemens SIMATIC ET 200eco PN - Page 233

Terminal block and voltage distributor
12.2 Voltage distributor
ET 200eco PN
Operating Instructions, 08/2016, A5E01250250-AJ
233
Technical data
Dimensions and Weight
Dimensions W x H x D (mm)
45 x 175 x 49
Weight Approx. 590 g
Voltages and currents
Supply voltage 1L+
DC 24 V
• Reverse polarity protection
Yes; against destruction (continuously without
load)
• Infeed current 1L+
8 A
Supply voltage 2L+
DC 24 V
• Reverse polarity protection
Yes; against destruction (continuously without
load)
• Infeed current 2L+
8 A
Total current of the outputs
• All mounting positions to 45 °C
for X1 and X2 in total max. 4 A for 1L+
for X1 and X2 in total max. 4 A for 2L+
for X3 and X4 in total max. 4 A for 1L+
for X3 and X4 in total max. 4 A for 2L+
• All mounting positions to 55 °C
for X1 and X2 in total max. 3 A for 1L+
for X1 and X2 in total max. 3 A for 2L+
for X3 and X4 in total max. 3 A for 1L+
for X3 and X4 in total max. 3 A for 2L+
• Number of outputs
4, with 1L+ and 2L+ each
Input voltage/loop-through
Green LED "1L+" and "2L+"
• Nominal value
DC 24 V
Short-circuit protection of the output
Yes, electronic
• Response threshold
Typ. 4.5 A
Power loss of the voltage distributor
Typ. 3.5 W
Insulation
Insulation test voltage
• Ethernet interface
1500 V
rms
(IEEE802.3)
• All other circuit elements
707 V DC (type test)
Electrical isolation
• Between 1L+ and 2L+
Yes
Status, interrupts, diagnostics
Diagnostics functions
• Input/output voltage
Green LED "1L" and "2L"