Siemens SIMATIC ET 200eco PN - Page 4

Preface
ET 200eco PN
4 Operating Instructions, 08/2016, A5E01250250-AJ
Guide
This manual describes the hardware of the ET 200eco PN distributed I/O device. It consists
of instructive sections and reference sections (specifications).
Topics covered in this manual include
● Installing and wiring the ET 200eco PN distributed I/O device
● Commissioning and diagnostics of the ET 200eco PN distributed I/O device
● Components of the ET 200eco PN distributed I/O device
● Article numbers
● Important terms are explained in the glossary.
● The index helps you to quickly find all texts relevant to your keyword.
Recycling and disposal
ET 200eco PN can be recycled owing to its low pollutant content.
For ecologically compatible recycling and disposal of your old device, contact a certificated
disposal service for electronic scrap.
Training Centers
Siemens offers corresponding courses to get you started with your ET 200eco PN distributed
I/O device and the SIMATIC S7 automation system. Please contact your local training
center.
Additional information can be found on the Internet (http://www.sitrain.com/index_en.html
).
Technical Support
Expert advice on technical questions with a wide range of demand-optimized services for all
our products and systems.
You can find Technical Support at the following address on the Internet
(https://support.industry.siemens.com/cs/ww/en/sc/2090
).
Additional support
If you have any further questions about the use of products described in this manual, and do
not find the right answers there, contact your local Siemens representative:
You can find your representative on the Internet
(http://www.automation.siemens.com/partner/guiwelcome.asp?lang=en
).
A guide to the technical documentation for the various SIMATIC products and systems is
available on the Internet (https://support.industry.siemens.com
).
The online catalog and ordering systems are available on the Internet
(http://mall.industry.siemens.com
).