Wiring
3.8 Wiring the voltage distributor
ET 200eco PN
Operating Instructions, 08/2016, A5E01250250-AJ
65
● If you are wiring your configuration, you must take into account the impact of cable length
on the supply voltage to the ET 200eco PN (permitted tolerance).
● The maximum input current of the voltage distributor is 8 A for 1L+ non-switched and 2L+
switched.
Do not exceed these values.
If you do not adhere to the maximum infeed currents and the cable cross-sections
required for these currents, you will risk overheating the cable insulation and contacts
resulting in damage to the device.
To Next Page
Loading...
