Documentation guide
1.1 Documentation on CPU 1515SP PC (F)
CPU 1515SP PC (F)
14 Manual, 05/2017, A5E32701806-AC
You can use the SIMATIC Automation Tool to run commissioning and maintenance activities
simultaneously on various SIMATIC S7 stations as a bulk operation independently of the TIA
Portal.
The SIMATIC Automation Tool provides a multitude of functions:
● Scanning of a PROFINET/Ethernet network and identification of all connected CPUs
● Address assignment (IP, subnet, gateway) and station name (PROFINET device) to a
CPU
● Transfer of the data and the programming device/PC time converted to UTC time to the
module
● Program download to CPU
● Operating mode switchover RUN/STOP
● Localization of the CPU by means of LED flashing
● Reading out CPU error information
● Reading the CPU diagnostic buffer
● Reset to factory settings
● Updating the firmware of the CPU and connected modules
You can find the SIMATIC Automation Tool on the Internet
(https://support.industry.siemens.com/cs/ww/en/view/98161300).
With SIEMENS PRONETA (PROFINET network analysis), you analyze the plant network
during commissioning. PRONETA features two core functions:
● The topology overview independently scans PROFINET and all connected components.
● The IO check is a fast test of the wiring and the module configuration of a system.
You can find SIEMENS PRONETA on the Internet
(https://support.industry.siemens.com/cs/ww/en/view/67460624).
Documentation on CPU 1515SP PC (F)
The following additional documentation is required for using the CPU 1515SP PC (F):
● Operating manual S7-1500 software controller
(http://support.automation.siemens.com/WW/view/en/109249299)
● System manual WinCC Advanced V14
(http://support.automation.siemens.com/WW/view/en/109742297)
● System manual ET 200SP distributed I/O system
(http://support.automation.siemens.com/WW/view/en/58649293)
● Manual Server module (http://support.automation.siemens.com/WW/view/en/63257531)
To Next Page
Loading...
