Siemens SIMATIC ET 200SP User Manual

CPU 1515SP PC (F)
40 Manual, 05/2017, A5E32701806-AC
Connection
5
5.1
Notes on connection
Note
Rules and regulations for operation
Observe the information contained in the
Wiring section in the system manual ET 200SP
distributed I/O system (
http://support.automation.siemens.com/WW/view/en/58649293) and
in the function manual Designing interference
-free controllers
(
http://support.automation.siemens.com/WW/view/en/59193566).
NOTICE
Fault caused by I/O devices
The connection of I/O devices can lead to faults on the device.
Injury to persons and damage to the machine or plant could result.
Note the following when connecting I/O devices:
• Read the documentation related to the I/O devices. Follow all instructions given in the
documentation.
• Only connect I/O devices which are suitable for use in industrial environments according
to EN 61000-6-2/EC 61000-6-2.
• You may only connect hot-plug capable I/O devices when the power supply is switched
off.
Note
Feedback through USB devices
If USB devices are connected which
- contrary to the USB 2.0 specification - feed voltage
back to the host interface, the startup of the CPU
1515SP PC (F) is not ensured upon power
-
up.
Regenerative feedback
is generally not permitted.

Siemens SIMATIC ET 200SP Specifications

General

System Type	Distributed I/O System
Mounting	DIN Rail
Communication Protocol	PROFINET, PROFIBUS
IP Rating	IP20
Category	I/O Systems
Supply Voltage	24 V DC
Modularity	Yes
Hot Swapping	Yes
Storage Temperature	-40°C to +70°C
Digital Inputs	Yes
Digital Outputs	Yes
Analog Inputs	Yes
Analog Outputs	Yes
Communication Interface	PROFINET, PROFIBUS
Number of Modules	Up to 64
Relative Humidity	5 to 95% (non-condensing)
Operating Temperature	-25°C to +60°C