Commissioning
7.3 Initial configuration of an Open Controller
CPU 1515SP PC (F)
Manual, 05/2017, A5E32701806-AC
53
Initial configuration of an Open Controller
Creating the configuration
You have created a new project in the TIA Portal.
To create the configuration in the TIA Portal, follow these steps:
1. Double-click "Add new device" in the project tree.
2. In "PC-Systeme > SIMATIC S7 Open Controller > ET 200SP Open Controller >", select
the "CPU 1515SP PC (F) (+HMI)".
3. Select the appropriate version.
The configured Open Controller is displayed in the device view.
4. The following components can be seen in the Open Controller:
– Onboard interface X2 (GB Ethernet Windows interface) that is assigned directly to the
PC station (1 port)
– Replaceable BusAdapter X1, which is directly assigned to the software controller (2
ports)
– On the right side (behind the plugged modules in the rack): the configured software
controller CPU 1505SP (F) and WinCC Runtime Advanced.
5. Insert the server module.
The server module at the right end of the configuration forms the termination of the CPU
with the I/O modules.
Setting the IP addresses:
In the Inspector window under "Properties":
● Onboard interface X2: the configured, specified IP address is identical with the Windows
IP address that is set during the first commissioning on the open controller.
● BusAdapter X1: the configured, specified IP address is identical with the IP address that
is set during the first commissioning in the panel of the software controller (display
application).
Important properties of the Software Controller
Change the properties in the Inspector window under "Properties" if required:
● Selecting startup type
● System diagnostics
● Setting the storage location for retentive data
● Setting up copy protection
● Using the LEDs of the hardware
● Configuring the Web server
● Assigning interfaces for the communication
To Next Page
Loading...
Need help?
General
