Siemens SIMATIC ET 200SP User Manual

Commissioning
7.2 Initial commissioning
CPU 1515SP PC (F)
52 Manual, 05/2017, A5E32701806-AC
User "Operator"
A user "Operator" with standard user rights is already created on the Windows system.
The user is in a user group "SIEMENS TIA Engineer". This grants the user the rights to use
the installed SIMATIC software products.
To be able to use the CPU 1515SP PC (F) directly, the Windows "Autologon" is activated for
the user "Operator". No password is preset.
Note
When you assign a password, change the entry for the Windows "Autologon" function
ac
cordingly in order that the function remains activated.
Administrator rights
You need administrator rights for the following actions:
● Back up the data in the root directory of the C partition.
● Installing the language pack
Screen resolution
In Windows Embedded Standard 7, the values that are determined for the monitor via the
DVI-I interface are set for the screen resolution.

Siemens SIMATIC ET 200SP Specifications

General

System Type	Distributed I/O System
Mounting	DIN Rail
Communication Protocol	PROFINET, PROFIBUS
IP Rating	IP20
Category	I/O Systems
Supply Voltage	24 V DC
Modularity	Yes
Hot Swapping	Yes
Storage Temperature	-40°C to +70°C
Digital Inputs	Yes
Digital Outputs	Yes
Analog Inputs	Yes
Analog Outputs	Yes
Communication Interface	PROFINET, PROFIBUS
Number of Modules	Up to 64
Relative Humidity	5 to 95% (non-condensing)
Operating Temperature	-25°C to +60°C