Commissioning
7.4 Installing license keys
CPU 1515SP PC (F)
Manual, 05/2017, A5E32701806-AC
55
Installing license keys
Licensing the software
A license key is not required to operate the S7-1500 software controller CPU 1505SP (F)
V2.x. The software controller is permanently coupled to your CPU 1515SP PC (F). It is not
necessary to input the key via the Automation License Manager!
WinCC RT Advanced requires a product-specific license key. This is located on the supplied
USB stick.
Prior to commissioning, you must install the license key for the HMI powertags using the
Automation License Manager (ALM)
.
Perform the licensing directly via the CPU 1515SP PC (F).
● Initial commissioning was successfully completed.
● Windows Embedded Standard 7 has started.
● The enhanced write filter
must be disabled on the CPU 1515SP PC (F).
Installing License keys with local configuration
The
Automation License Manager
is preinstalled on the CPU 1515SP PC (F).
Open the software using the icon on the desktop or a menu command.
1. In the Windows start bar, select
Start > All Programms > Siemens Automation >
Automation License Manager
.
2. Follow the instructions of the
Automation License Manager
.
Using a programming device/PC to install the license keys
The
Automation License Manager
is pre-installed on a programming device / PC with
STEP 7 and the CPU 1515SP PC (F).
1. Connect the CPU 1515SP PC (F) to a programming device / PC.
2. Connect the supplied USB stick to the programming device/PC.
3. Select the menu command
Start >SIMATIC >License Management
> Automation
License Manager
.
4. Select the menu command
Bearbeiten > Rechner verbinden
and enter the IP address of
the CPU 1515SP PC (F) (default 192.168.1.1).
5. Drag the license keys from the USB stick to the system partition C: of the
CPU 1515SP PC (F).
To Next Page
Loading...
Need help?
General
