Siemens SIMATIC ET 200SP User Manual

Commissioning
7.6 Switching CPU 1515SP PC (F) on/off
CPU 1515SP PC (F)
58 Manual, 05/2017, A5E32701806-AC
7.6
Switching CPU 1515SP PC (F) on/off
Requirements
Initial commissioning was successfully completed.
Switching on the CPU 1515SP PC
1. Switch on the power supply of the CPU.
The Boot Manager GRUB4DOS opens.
2. Select the mode in which the CPU 1515SP PC (F) should start:
– Only with the Windows operating system.
– With the Windows operating system and the S7-1500 software controller (default).
Figure 7-1 Boot Manager GRUB4DOS
Switch off CPU 1515SP PC (F)
1. To switch off the Windows function, use
StartShut down
.
The PWR LED changes from green to yellow.
The Windows function shuts down the Windows operating system and the S7-1500
software controller.
If the device will not be used for a longer period after the shutdown, de-energize the device.

Siemens SIMATIC ET 200SP Specifications

General

System Type	Distributed I/O System
Mounting	DIN Rail
Communication Protocol	PROFINET, PROFIBUS
IP Rating	IP20
Category	I/O Systems
Supply Voltage	24 V DC
Modularity	Yes
Hot Swapping	Yes
Storage Temperature	-40°C to +70°C
Digital Inputs	Yes
Digital Outputs	Yes
Analog Inputs	Yes
Analog Outputs	Yes
Communication Interface	PROFINET, PROFIBUS
Number of Modules	Up to 64
Relative Humidity	5 to 95% (non-condensing)
Operating Temperature	-25°C to +60°C