Siemens SIMATIC ET 200SP User Manual

Maintenance
9.3 Restoring the delivery state
CPU 1515SP PC (F)
Manual, 05/2017, A5E32701806-AC
93
Requirements
To restore the original software of the CPU 1515SP PC (F), the following is required:
● A CFast card. Minimum size of the CFast card for the CPU 1515SP PC (F):
– WES7 E 32Bit 4GB RAM: 8 GB
– WES7 P 64Bit 4GB RAM: 16 GB
● A DVD drive with external power supply
● The supplied Restore DVD. Alternatively, a bootable USB stick
● A data backup
NOTICE
Data loss
During restoration of the system to delivery state, the CFast card is completely erased and
re-formatted, and is then loaded with the original software. All subsequently modified or
added data, programs, license keys and partitions on the CFast card will be lost.
Back up the data of the CPU 1515SP PC (F), after you have assigned parameters to the
module and if you have made changes to the configuration.
NOTICE
Loss of license keys
Back up the license keys before the restore by dragging these to your USB stick via
Automation License Manager .
After the restart of the CPU 1515SP PC (F), re-install the license keys on the device via the
Automation License Manager .

Siemens SIMATIC ET 200SP Specifications

General

System Type	Distributed I/O System
Mounting	DIN Rail
Communication Protocol	PROFINET, PROFIBUS
IP Rating	IP20
Category	I/O Systems
Supply Voltage	24 V DC
Modularity	Yes
Hot Swapping	Yes
Storage Temperature	-40°C to +70°C
Digital Inputs	Yes
Digital Outputs	Yes
Analog Inputs	Yes
Analog Outputs	Yes
Communication Interface	PROFINET, PROFIBUS
Number of Modules	Up to 64
Relative Humidity	5 to 95% (non-condensing)
Operating Temperature	-25°C to +60°C