Using PID basic functions
7.1 CONT_C
PID control
Function Manual, 03/2017, A5E35300227-AC
209
Configure the controller algorithm CONT_C
General
To determine which components of the control algorithm are activated, proceed as follows:
1. Select an entry from the "Controller structure" list.
You can only specify required parameters for the selected controller structure.
1. If the controller structure contains a proportional action, enter the "proportional gain".
1. If the controller structure contains an integral action, enter the integral action time.
2. To give the integral action an initialization value, select the check box "Initialize integral
action" and enter the initialization value.
3. In order to permanently set the integral action to this initialization value, select the
"Integral action hold" check box.
1. If the controller structure contains a derivative action, enter the derivative action time, the
derivative action weighting and the delay time.
How CONT_C works (Page 450)
To Next Page
Loading...
Need help?
General
