Siemens SIMATIC S7-1500T Function Manual

Configuring a software controller
3.10 Parameter view
PID control
Function Manual, 03/2017, A5E35300227-AC
55
3.10.4
Default setting of the parameter view
Default settings
To enable you to work efficiently with the Parameter view, you can customize the parameter
display and save your settings.
The following customizations are possible and can be saved:
● Show and hide columns
● Change column width
● Change order of the columns
● Toggle navigation
● Select parameter group in the navigation
● Selection of compare values
Show and hide columns
To show or hide columns in the parameter table, follow these steps:
1. Position the cursor in the header of the parameter table.
2. Select the "Show/Hide" command in the shortcut menu.
The selection of available columns is displayed.
3. To show a column, select the check box for the column.
4. To hide a column, clear the check box for the column.
or
1. Position the cursor in the header of the parameter table.
2. Select the "Show all columns" command in the shortcut menu if all columns of the offline
or online mode are to be displayed.
Some columns can only be displayed in online mode: see Parameter table (Page 52).

Siemens SIMATIC S7-1500T Specifications

General

Brand	Siemens
Model	SIMATIC S7-1500T
Category	Controller
Language	English