Siemens SIMATIC TI505 User Manual

Index-4
Q
Quadrature modes
1X quadrature counting, 1-7
2X quadrature counting, 1-8
4X quadrature counting, 1-8
minimum input pulse width, C-5
R
Rate, time sampled counting, A-3
Recycle mode, 1-10
Related manuals, xiii
Reset and go jumper , 5-11
RESET signal, 1-4
Response time of module, C-7
Retriggerable one-shot
counting, 1-19
Up/Down counting, A-4
RLL programming, 4-5, 5-20
Rollover
jumper, 5-11
outputs, 1-12
Run
flag, 3-7
mode, 3-7
S
Sampled cumulative counting, A-2
Setup words
program mode, 3-8–3-9
run mode, 3-10–3-1 1
Signed integer , 3-5
Software, optional features, 4-4
Software compatibility , xiii, 1-5
Software setup options
16-bit counters, 5-18
24-bit counters, 5-12–5-15
Specifications
electrical, C-3–C-6
environmental, C-2
input, C-3–C-6
output, C-7
Square wave generator counting
even initial value, 1-22, 1-23
odd initial value, 1-23
Status
LEDs, 2-12, B-2
words, 3-6–3-7
Strobe, triggered configuration, 1-21
T
T ask 8, 1-5
T elephone number , for assistance, xiv
T erminal block, 2-4
connecting, 2-1 1
wiring, 2-6
worksheets, B-4–B-7
T erminal blocks, 2-5
T ime sampled rate counting, A-3
Trigger , defined, 1-17
T riggered strobe
counting, 1-21
Up/Down counting, A-5
T riggering, 16-bit counters, 1-17
T roubleshooting, B-3

Siemens SIMATIC TI505 Specifications

General

Brand	Siemens
Model	SIMATIC TI505
Category	Control Unit
Language	English