Siemens SIMODRIVE 611 digital - Page 431

05.01
D-431
© Siemens AG 2008 All Rights Reserved
SIMODRIVE 611 Configuration Manual (PJU) – 05/2008 Edition
Internal cooling, 2-59, 9-335
Internal pulsed resistors, 6-188
Internet address, iii
Inverter clock cycle frequency, Derating, 4-91
L
Leading contact, 7-218
Line choke, 6-169
Line filter
Basic Line Filter, 7-223, 7-227
For I/R modules, 7-223
For UI modules, 7-223
Wideband Line Filter, 7-223
Wideband line filter, 7-224
Line fuses, 7-208
Line infeed, 6-149
Line supply connection, 1-24, 5-135, 5-143, 6-161
Line system configurations, 7-197
IT-line supply, 7-200
TN-C line supply, 7-198
TT line supply, 7-199
Load duty cycle definitions, 4-89
M
Main Spindle Drive
Master drive, 8-298
Slave drive, 8-298
Main switches, 7-218, 8-231
Master/slave operation, 8-298
Minimum cross–section for PE, 7-202
Module
ANA module, 5-140
Braking module, 1-24
Capacitor module, 1-24, 6-180
HLA module, 5-132
Infeed module, 1-24
Monitoring module, 1-24, 6-176
Overvoltage limiter module, 2-62
Power module, 1-24
VP module, 2-48
Modules
Braking module, 6-188
Overvoltage limiter module, 6-187
Power module, 4-83
Monitoring module, 1-24, 6-150, 6-176
Adaptation conditions, 6-161
LED display, 6-178
Mode of operation, 6-178
Motor
Encoder, 3-66
Overview, 1-25
Protection, 3-65
Selection, 2-48, 3-65
with holding brake, 3-65
Motor changeover, 8-303
Motor encoder, 3-66
Motor holding brake, 5-110
Motor rotor position sensing, 3-70
Motor speed sensing, 3-70
Mounting and installing the modules, 2-45
N
NCSD Configurator, 1-27
NE module
Adaptation conditions, 6-161
Block diagram, 6-153
Interface overview, 6-171
Nominal load duty cycles, 6-162
Settings, 6-154
Network failure, 8-245
Method of operation, 8-308
No ground faults, 6-161
Nominal load duty cycles
FDD, 4-89
MSD-IM, 4-89
MSD-SRM, 4-89
Notes
Danger and warning information, v
Hotline, iii
Questions about this documentation, iii
regarding the danger of electrostatic
discharge, xii
Target group, iii
Technical, vii
Technical Support, iii
O
One-axis drive control, 5-103
Operation when the power fails, 8-308
Optional module
PROFIBUS-DP, 5-111
TERMINALS, 5-111
Ordering notes, 1-27
Overload protection, 8-307
Overview, 1-23
Overvoltage limiter module, 6-187
D Index05.08
Aotewell Ltd
www.aotewell.com
Industry Automation
HongKong|UK|China
sales@aotewell.com
+86-755-8660-6182