05.01
D-430
© Siemens AG 2008 All Rights Reserved
SIMODRIVE 611 Configuration Manual (PJU) – 05/2008 Edition
Cooling components, 6-165
Cooling types, 1-26, 2-57
Current documentation, iv
Current reduction, 4-90
D
DAC assignment, 5-139
Danger information, v
Data volume, 5-111
DC link
Braking module, 6-188
Buffering, 8-311
Capacitor module, 6-180
Charge/discharge times, 6-187
Energy balance, 8-311
External pulsed resistors, 6-191
Overvoltage limiter module, 6-187
DC link voltage, 8-245
Declaration of Conformity, C-417
Definition
of the currents, 4-86
of the load duty cycles, 4-89
of the power ratings, 4-86
Derating, 6-164
Inverter clock cycle frequency, 4-91
Dimension drawings, 12-349
Direct position sensing, 3-70
Discharge times, 6-187
Discharge voltage, 6-187
Drive bus, 2-45, 5-103
Drive line–up, 2-41
E
EC Declaration of Conformity, C-417
EMC Design Guidelines, 9-329
EMC legislation, 7-222
EMC measures, Grounding, electronics ground,
9-334
Encoder cables, Ordering notes, 3-81
Encoder power supply
Motor measuring system, 3-74
SSI encoder, 3-76
EnDat interface, 5-103
Engineering steps, 1-27
Equipment bus, 2-45
ESDS information and instructions, xii
Example
Motor changeover, 8-306
Motor parallel operation, 8-304
Star-delta operation, 8-299
Typical circuit diagram, 8-269
Explanation of symbols, v
External cooling, 2-60
External pulsed resistors, 6-191
F
Fan, 6-166
Field–weakening range, 8-303
Folder
of dimension drawings, 12-349
of references, B-415
Fundamental principles when engineering a drive
Braking module, 2-44
Checking the DC link capacitance, 1-29
DC link capacitance, 1-29
Dimensioning, 1-29
Drive bus, 2-44
Equipment bus, 2-44
Feed axes, 1-29
Length of cable, 2-44
Power supply rating, 1-29
H
Help for the reader, v
HFD commutating reactor, 6-167
High–voltage test, 9-340
HLA module
Connecting–up, 5-134
System components, 5-133, 5-141
Holding brake, 3-65, 5-110, 8-294
Hose package, 6-165
Hotline, iii
I
I/R module
Autotransformer, 7-212
Technical specifications, 6-158
Transformer, 7-216
I/R module with HFD reactor, 6-149
Indirect position sensing, 3-70
Induction motor
Motor changeover, 8-306
Parallel operation, 8-304
Series reactor, 8-302
Star-delta operation, 8-299
Infeed modules, 1-24, 6-149
Installation altitude, 2-46
Installation conditions, 9-335
Installation regulations, 9-329
Interface overview, Bus interfaces, 5-147
D Index 05.08
To Next Page
Loading...
