Siemens SINAMICS S120 - Leds on the Voltage Sensing Module (VSM) in the Active Interface Module

Diagnostics
7.10 LEDs on the Voltage Sensing Module (VSM) in the Active Interface Module
Cabinet Modules NEMA
Manual, 04/2014, A5E03586450A
343
7.10
LEDs on the Voltage Sensing Module (VSM) in the Active Interface
Module
Table 7- 19 Meaning of the LEDs on the Voltage Sensing Module in the Active Interface Module
LED
Color
Status
Description
RDY
(READY)
--- Off The electronics power supply is missing or lies outside the permissible tolerance
range.
Green Continu-
ous light
The component is ready for operation and cyclic DRIVE-CLiQ communication is
taking place.
Orange Continu-
ous light
DRIVE-CLiQ communication is being established.
Red Continu-
ous light
At least one fault is present in this component.
Note:
LED is activated irrespective of any reconfiguring of the corresponding messages.
Green/
Red
Flashing
0.5 Hz
Firmware is being downloaded.
Flashing
2 Hz
Firmware download is being completed.
Waiting for POWER ON.
Green/
Orange
or
Red/
Orange
Flashing
2 Hz
Detection of the component via LED is activated (p0144).
Note:
The two options depend on the LED status when component detection is activated
via p0144 = 1.