Mechanical installation
3.3 Installation
Cabinet Modules NEMA
Manual, 04/2014, A5E03586450A
59
Connection for side-by-side installation of cabinet units
Description
An accessory kit is provided with each cabinet or transport unit for the connection of cabinet
units in a side-by-side installation. The table below shows the content of this accessory kit for
connecting the cabinet units.
Table 3- 3 Content of the accessory kit for connecting the cabinet units
1 x Sealing strip The sealing strip must be glued on before assembling
3 x Outer cabinet connectors
including fasteners
The cabinet connector is fitted and screwed on from
the outside.
Tightening torque: 9 Nm
3 x Inner cabinet connectors
including fasteners
The cabinet connector is fastened with 4 screws.
Tightening torque: 5 Nm
1. Glue sealing strip to the cabinet cross-beams of the cabinets to be connected.
2. Push the cabinets together. The front and rear sides of all cabinets must stand next to
each other. The distance between the cabinets must be approximately 0.12 inch (3 mm).
3. Install the outer and inner cabinet connectors according to the following drawing.
4. If necessary, reattach the protective covers and doors. The earth connections must also
be attached to the doors.
To Next Page
Loading...
