Detailed Description
2.2 Dimensional information for transverse axes
Transverse Axes (P1)
Function Manual, 08/2005 Edition, 6FC5397-0BP10-0BA0
2-3
DIAMON
• Display data of transverse axis in the workpiece coordinate system:
– Setpoint and actual position
– Distance-to-go
– Repos offset
• "JOG" mode:
– Increments for incremental dimension (INC) and travel with handwheel
• Part program programming:
– End positions, independent of reference mode (G90 / G91)
– Interpolation parameters of circular-path programming (G2 / G3) if these are
programmed with part program instruction: AC absolute.
• Actual values read with reference to the workpiece coordinate system:
– $AA_MW[
Transverse axis
]
System variable of the measuring functions MEAS (measuring with delete distance-to-
go) and MEAW (measuring without delete distance-to-go)
– $P_EP[
Transverse axis
]
– $AA_IW[
Transverse axis
]
DIAM90
After activation of the reference-mode-dependent diameter programming, the following data
are always displayed in relation to diameter regardless of the operating mode (G90 / G91):
• Actual value
• Actual values read with reference to the workpiece coordinate system:
– $AA_MW[
Transverse axis
]
System variable of the measuring functions MEAS (measuring with delete distance-to-
go) and MEAW (measuring without delete distance-to-go)
– $P_EP[
Transverse axis
]
– $AA_IW[
Transverse axis
]
To Next Page
Loading...
