Siemens SINUMERIK

Programming and Operating Manual (Turning)
01/2017
219
17.
Press this softkey to open the window for CYCLE95 again. Move the cursor to the input field
of "VARI".
18.
Press this key to change the value to "5".
19.
Press this softkey to accept the change.
20.
Press this key to enter a new line.
Continue to enter the following program blocks:
G0 X100 Z100
M05
M30
Then you can proceed with
the operations for "program simulation and execution
(Page 242)".
Screenshots of the complete program
Screen 1:
Screen 2:
Operating sequence for programming in ISO mode
+
1.
Select the system data operating area.
2.
Press this softkey and the system prompts the following window:
3.
Press this softkey and control system automatically starts the mode change from Siemens
mode to ISO mode.
4.
Select the program management operating area.