Programming and Operating Manual (Turning)
01/2017
291
G59 6. Settable work offset
Settable work offset OFF, non-modal
9: Suppressing the settable work
offset, non-modal
G153 Settable work offset OFF, non-modal, in-
10: Approach behavior, modally
effective
G62 Corner deceleration at inside corners when
tool radius offset is active (G41, G42)
Only in conjunction with continu-
G62 Z... G1
G9 Non-modal exact stop 11: Non-modal exact stop, non-
Exact stop window, fine, with G60, G9
12: Exact stop window, modally
effective
Exact stop window, coarse, with G60, G9
G621 Corner deceleration at all corners Only in conjunction with continu-
G621 AIDS=...
13: Inch/metric dimension data,
modally effective
Metric dimension data input
G700
Inch dimension data input; also for feedrate
F
G710 Metric dimension data input; also for
feedrate F
Absolute dimension data input
14: Absolute/incremental dimen-
sion, modally effective
Incremental dimension input
15: Feedrate/spindle, modally
effective
Feedrate F in mm/spindle revolutions
G96 Constant cutting rate ON
(F in mm/rev., S in m/min)
G96 S... LIMS=... F...
Constant cutting speed OFF
18: Behavior at corners when
working with tool radius com-
pensation, modally effective
G451 Point of intersection
Jerking path acceleration
21: Acceleration profile, modally
effective
Jerk-limited path acceleration
24: Feedforward control, modally
effective
29: Dimension radius/diameter,
modally effective
47: External NC languages,
modally effective
G291 External mode
To Next Page
Loading...
Need help?
General
