Procedure for mounting on a level surface
Step Instructions Figure
1 Insert the push-in lugs for screw xing into the
openings provided on the device until they engage.
2 Hold the device up to the surface prepared for screw
fastening.
3 Insert the screws through the elongated holes into
the push-in lugs for screw xing.
4 Screw the device onto the level surface so that it is
secure.
5.2.4 Mounting the PROFINET interface on a standard mounting rail
Requirements
• A horizontal 35 mm wide mounting rail in accordance with EN 60715 has been properly
secured at the installation location.
Description of the hardware
5.2 Mounting / installing / attaching
SIRIUS 3RK3 Modular Safety System
126 Equipment Manual, 07/2020, NEB926253002000/RS-AC/006
To Next Page
Loading...
