Siemens SIRIUS 3RK3 - Establishing a 3 SK25 PROFINET Interface Connection

Procedure
Step Instructions Figure
1 Press the clip of the terminal block upwards.


2 Pull the terminal out to the front.
3 Lift the terminal out of the guide rail of the de‐
vice.
5.3.4.10 Establishing a 3SK25 PROFINET interface connection
Con󹪝guration guidelines
You can 󹪝nd information about the installation guidelines in Chapter "Additional documentation
(Page 15)".
Requirements
PROFINET IO RJ45 connecting cable is available.
Note
Bending radii of the PN cables
The bending radii that are speci󹪝ed in the documentation of the connecting cable must be
complied with.
Description of the hardware
5.3 Connecting / wiring
SIRIUS 3RK3 Modular Safety System
168 Equipment Manual, 07/2020, NEB926253002000/RS-AC/006