Procedure
Step Instructions Figure
1 Pull the device down until the lower half
can be pulled away from the DIN rail.
2 Pull the lower half of the device away
from the DIN rail.
3 Lift the device from the upper edge of
the DIN rail.
5.2.9 Removing the diagnostics display
Requirements
• The interface connections are disconnected.
Removing the diagnostics display from a control cabinet door / control panel
Step Instructions Figure
1 Take appropriate measures to ensure the
diagnostics display does not fall out of
the control cabinet door/control panel.
2 Unscrew the screws of the four xing
brackets on the rear.
2 Remove the xing brackets.
3 Pull the diagnostics display out of the
mounting cut-out from the front.
Description of the hardware
5.2 Mounting / installing / attaching
SIRIUS 3RK3 Modular Safety System
Equipment Manual, 07/2020, NEB926253002000/RS-AC/006 131
To Next Page
Loading...
