Siemens SIRIUS 3RK3 - Standard Mode with Status Display

Operating elements of the DP interface
Pushbutton Meaning
SET Operating the display
MODE Operating the display
LED statuses
LED Meaning
DEVICE Status
BF Bus error
SF Group error
6.4.4.2 Standard mode with status display
Messages
Various status messages are output during normal operation:
Display Meaning
RUN•
DPXXX
1st line not 󹪞ashing
2nd line: DP address
No error
SF••
SB•••
1st line 󹪞ashing
2nd line not 󹪞ashing
System fault
No connection to the safety relay via system inter‐
face.
BF••
noEx•
1st line 󹪞ashing
2nd line not 󹪞ashing
Bus error
No process data exchange with DP master.
BF••
CFG••
1st line 󹪞ashing
2nd line not 󹪞ashing
Bus error
Error in con󹪝guration
BF••
PRM••
1st line 󹪞ashing
2nd line not 󹪞ashing
Bus error
Parameterization error
BF••
noCon
1st line 󹪞ashing
2nd line not 󹪞ashing
Bus error
No connection with DP master.
If several messages are active, a cursor line runs from one end of the a󹪜ected line to the other.
To scroll through the messages, press "MODE".
A corrected error is automatically deleted from the display.
If you do not press any buttons for 30 seconds, the display automatically returns to the error with
the highest priority.
Operation
6.4 Integrating into DP master systems
SIRIUS 3RK3 Modular Safety System
198 Equipment Manual, 07/2020, NEB926253002000/RS-AC/006