Procedure
Table 5-1 Rigid conductors or conductors equipped with end sleeves
Step Instructions Figure
1 Insert the cable into the oval opening as far as it
will go.
2 Pull on the cable to ensure it is tight.
Table 5-2 Finely-stranded conductors
Step Instructions Figure
1 Insert the screwdriver in the rectangular open‐
ing to open the terminal (oval opening).
2 Insert the cable as far as it will go into the oval
opening and remove the screwdriver.
3 Pull on the cable to ensure it is tight.
5.3.4.7 Disconnecting the push-in terminals
WARNING
Hazardous Voltage
Can Cause Death, Serious Injury, or Property Damage.
Before starting work, therefore, disconnect the system and devices from the power supply.
Requirements
• Screwdriver DIN 5264 of the size 0.5 x 3 mm
Description of the hardware
5.3 Connecting / wiring
SIRIUS 3RK3 Modular Safety System
Equipment Manual, 07/2020, NEB926253002000/RS-AC/006 165
To Next Page
Loading...
