Requirements
PROFIBUS DP connection cable with 9-pin sub‑D connector is available.
Connection to PROFIBUS DP
Step Instructions Figure
1 Connect the PROFIBUS DP connector to the PRO‐
FIBUS DP interface.
2 Tighten the screws on the PROFIBUS DP connec‐
tor.
3 If the device is located at the end of the PROFI‐
BUS DP cable, switch on the terminating resistor
on the PROFIBUS DP connector.
Description of the hardware
5.3 Connecting / wiring
SIRIUS 3RK3 Modular Safety System
152 Equipment Manual, 07/2020, NEB926253002000/RS-AC/006
To Next Page
Loading...
