Siemens SIRIUS 3RK3 - Page 200

Key functions
The menu option DP•• is used to change the PROFIBUS address. You start input of the hundreds
digit by pressing "SET".
The buttons have the following functions when entering the address:
Pushbutton Result
"SET"
• Accepting the setting
• Moving to the next digit:
Hundreds, tens, units digit
• Acceptance of the DP address following input of the units digit
"MODE"
• Setting the 󹪞ashing digit of the DP address
• Counts up
Double-click on "SET"
• Jumps back one place to the previous digit:
Units, tens, hundreds digit
Double-click on "MODE"
• Sets the 󹪞ashing digit of the DP address
• Counts down
"MODE" and "SET" simul‐
taneously
• The operation is canceled.
"EXIT" must then be con󹪝rmed by pressing "SET".
Example: Setting the hundreds digit
Display Action
DP••
••*26
1st line: not 󹪞ashing
2nd line: 1st digit in DP address
󹪞ashing
The 2nd line in the display contains the current DP
address (0 ... 126; right-justi󹪝ed). If an address has
not yet been set, the default address 126 is dis‐
played.
• By pressing "MODE", the hundreds are incre‐
mented (sequence: 0, 1, 0, etc.)
• When you choose "SET", this digit is con󹪝rmed
and the system switches to the tens.
• By double-clicking on "SET", you can go back
one digit (i.e. from the hundreds to the units).
The address is not applied when you do this.
Result
Display Meaning
•XXX
OK•••
1st line: not 󹪞ashing
2nd line: 󹪞ashing
The message above indicates that the PROFIBUS
address was successfully saved. You can acknowl‐
edge this message by choosing "SET" or "MODE".
The display then returns to standard mode.
The set PROFIBUS address is applied immediately
on the bus side. You do not need to switch the
power OFF / ON.
Operation
6.4 Integrating into DP master systems
SIRIUS 3RK3 Modular Safety System
200 Equipment Manual, 07/2020, NEB926253002000/RS-AC/006