Siemens SITRANS F - Page 8

Manual Addendum
1010FMA-56
A-2
Vs Min m/s Vs Min M/S
Channel/Path Setup Chan/Path Setup
Vfmax GAL/MIN Vfmax
Date Site Created: Site Created:
Empty % Empty
Analog Output Trim Analog Out Trim
Pick flowtube size and type Select flowtube
and start operation
Empty Flowtube Set Empty Pipe Set
Version 3 Version 5
Gas Flowmeter Flow and VoS Unit Changes
1. Flowmeter Types
Flowmeter configurations included with this change include all SITRANS F Gas Flowmeters (7ME361*).
2. Flow Units
The table below describes the translation from the current gas flow units to the new gas flow units,
where only Cubic Feet and Cubic Meter volume units are affected. Also note that M = thousands and
MM = millions. Mass units and Velocity units remain unchanged.
Note: The flow legend changes depending upon the selection of Standard Volume enabled or
disabled.
FLOW UNITS
For STD VOLUME disabled For STD VOLUME enabled
Version 3 Version 5 Version 3 Version 5
CU FT/SEC ACFS CU FT/SEC SCFS
CU FT/MIN ACFM CU FT/MIN SCFM
CU FT/HR ACFH CU FT/HR SCFH
CU FT/DAY ACFD CU FT/DAY SCFD
KCU FT/SEC MACFS KCU FT/SEC MSCFS
KCU FT/MIN MACFM KCU FT/MIN MSCFM
KCU FT/HR MACFH KCU FT/HR MSCFH
KCU FT/DAY MACFD KCU FT/DAY MSCFD
MCU FT/SEC MMACFS MCU FT/SEC MMSCFS
MCU FT/MIN MMACFM MCU FT/MIN MMSCFM
MCU FT/HR MMACFH MCU FT/HR MMSCFH
MCU FT/DAY MMACFD MCU FT/DAY MMSCFD
CU M/SEC M3/sec M/SEC NM3/sec
CU M/MIN M3/min CU M/MIN NM3/min
CU M/HR M3/hr CU M/HR NM3/hr
CU M/DAY M3/day CU M/DAY NM3/day
KCU M/SEC E3 M3/sec KCU M/SEC E3 NM3/sec
KCU M/MIN E3 M3/min KCU M/MIN E3 NM3/min
KCU M/HR E3 M3/hr KCU M/HR E3 NM3/hr
KCU M/DAY E3 M3/day KCU M/DAY E3 NM3/day
MCU M/SEC E6 M3/sec MCU M/SEC E6 NM3/sec
MCU M/MIN E6 M3/min MCU M/MIN E6 NM3/min
MCU M/HR E6 M3/hr MCU M/HR E6 NM3/hr
MCU M/DAY E6 M3/day MCU M/DAY E6 NM3/day