Manual Addendum
1010FMA-56
4. Sound Velocity Units
Sound velocity will continue to be reported in units of meters/sec for metric units but will change to
Feet/sec for English unit selection. The flowmeter will display M/S and F/S to represent these two
variations.
Note: The units for Sound Velocity will be based on the [Preferred Units] menu item found in
the [Meter Facilities] menu and can not be changed unless a new site is created.
5. Transducer Model Menu Name
The following table lists the operating system menu item differences between Version 3 Hi Precision
and Version 5 Hi Precision transducer model names that appear on the [Install Xdcr] menu. Note that
T1, T2 and T3 indicate the different temperature ranges of the transducer.
3. Total Units
Total units are similar to flow units.
TOTALIZE UNITS
For STD VOLUME disabled
Version 3 Version 5
CU FT ACF
KCU FT MACF
MCU FT MMACF
CUM M3
KCU M E3 M3
MCU M E6 M3
TOTALIZE UNITS
For STD VOLUME enabled
Version 3 Version 5
CU FT SCF
KCU FT MSCF
MCU FT MMSCF
CUM NM3
KCU M E3 NM3
MCU M E6 NM3
A-3
Version 3 Transducers Version 5 Transducers
Hi Precision Hi Precision
1011HG Hi Prec. 1011HP-T1
1011HP-T2
1011HP-T3
To Next Page
Loading...
