FUE1010 IP65 NEMA 4X
Operating Instructions, 12/2014, A5E03086491-AC
147
The following is list of troubleshooting tips and messages that you may encounter. They
include explanations and, in some cases, a recommended action. If a problem seems
unsolvable, contact your local Siemens office or regional Ultrasonic Flow Representative for
expert help at: http://www.automation.siemens.com/partner
(http://www.automation.siemens.com/partner
).
Table 10- 1 Troubleshooting Tips
Memory Full! Response to an attempt to save site
data, when data memory is full.
Delete an obsolete site or clear Data-
logger memory to make room for the
Memory Corrupted! Memory read error occurred while
accessing the active site data.
Refer to F4 reset procedure in the
Operation Instructions manual.
Chan Not Setup Response to an attempt to invoke an
operation that requires a channel to be
enabled.
Enable the channel [Channel Setup -
Channel Enable - Yes]. Note that a
channel cannot be enabled until an
"Install" operation is completed.
Clr Active Memory? Response to pressing and holding the
F4 key during power-up
Use the F4 function to restore opera-
tion if a severe event (e.g., a violent
power surge) disrupts system opera-
Clr Saved Data? [Clr Saved Data?] only appears after
pressing the <Down Arrow> in re-
sponse to [Clr Active Memory?].
Answering Yes to [Clr Saved Data?]
will erase
saved data. To invoke in
RS-232 serial mode, type @@@ and
<EOT> Response to a request to output Data-
logger data to the printer or the
Graphics screen when no Datalogger
data exists or at the end of a transmit-
ted file.
Set up the Datalogger.
No Sites - Press <ENTER> Response while trying to recall/delete a
site setup when no sites are stored.
Create a site.
Security Response upon changing previously
entered data when security switch is in
[Disable] position or security code has
• Change switch position to [Enable].
• Enter previously set security code.
RTC Error Component level problem.
• Meter requires service. Request
RMA.
To Next Page
Loading...
