Siemens SITRANS FUE1010 IP65 NEMA 4X - Table 7- 3 Logger Control Menu Option List

Functions
7.3 Logger Control
FUE1010 IP65 NEMA 4X
Operating Instructions, 12/2014, A5E03086491-AC
107
Logger Control
To access the [Logger Control] menu the [Meter Facilities] menu must be selected.
1. From the Meter Facilities menu access the [Logger Control] menu by pressing the <Right
Arrow>.
2. Scroll down to [Logger Control]. Press the <Right Arrow> to access the [Logger Control]
menu option list.
Table 7- 3 Logger Control Menu Option List
Logger Control Display Logger Off
Line Wrap
No Line Wrap
Output Logger No
Yes
Circular Memory (Available for
Multi-Path units only)
No
Yes
Est LogTime Left
--:--
Clear Logger No
Yes
Display Logger
This menu cell is essentially a duplicate of the menu cell in Logger Setup. It allows you to
send the Logger contents to the display screen. This command is effective only after a
successful install. In addition, you have to enable datalogging and select items in the [Logger
Setup] menu. Note that this command transmits the data from both paths. You can set the
report to scroll on the screen with or without line wrap.