Connecting
5.5 Sensor Installation
FUE1010 IP65 NEMA 4X
Operating Instructions, 12/2014, A5E03086491-AC
57
Figure 5-8 Direct Mount (Pipe shown from above in 12 o'clock position)
The following items will be needed to mount the sensors (most are supplied):
● Flat blade screwdriver
● Mounting Frames or Mounting tracks
● Tape, chalk and a ruler or measuring tape
● Mounting Straps
● Spacer Bar
● Mounting Guide (for Direct Mount)
● Ultrasonic coupling compound and/or coupling pads
● Sensors (matched set)
The available Mounting Strap kits are listed below. Each kit comes with up to two band sizes
to cover its designated pipe diameter range and a spacing guide for Direct Mount.
50.8mm (2-inch) to 177.8mm (7-inch)
50.8mm (2-inch) to 330.2mm (13-inch)
7ME396000SM20 330.2mm (13-inch) to 609.6mm (24-
#188 (2) #280 (2)
7ME396000SM30 609.6mm (24-inch) to 1219.2mm (48-
#152 (4) #312 (4)
To Next Page
Loading...
