Functional Description
AP10
Date: 28.02.2022 Art. No. 86853 Mod. status 37/22 Page 15 of 78
Calibration value (see object 6003h: Preset value (calibration value))
Offset value (see object 2001h: Application Offset)
4.5.2 Restore factory settings
There are various options for restoring the factory settings of the device:
Factory settings are restored
Manual
This is only possible if the
configuration is enabled via
the keyboard (see object
2005h: Configuration enable
via keyboard and delay of
start of configuration).
all except bus parameters
CANopen
(see object 1011h: Restore
Parameter)
only Draft-Standard-406 parameters
only manufacturer-specific parameters
Table 8: Access to factory settings
Procedure for access via CANopen:
1. Execute object 1011h.
2. Device restart. Now all desired parameters are set to factory settings (volatile).
3. Permanent recovery: execute object 1010h: Store Parameter.
The bus parameters are:
To Next Page
Loading...
Need help?
General
