SIMPLEX 4100 EWIS Page 51
INSTALLATION MANUAL
Document No.: 4100-M011 March 1998 Issue 1.0
4 PROGRAMMERS REPORT
The Programmer’s Report is used to identify peripheral connections within the panel
and specifies system operational data.
The 13 sections within the Programmer’s Report are shown in Tables 5 through 17,
and explained in each section.
4.1 GENERAL INFORMATION
This section contains branch office required information. It details branch personnel
involved with the system, system power data, agency, and software information.
The software revision must match the system CFIG chip label for proper operation of
the LCD display.
--------------------------------------------------------------------------------
XYZ BUILDING GENERAL INFORMATION Page 1
2796 node:1 rev:6 14:41:55, WED, 25-MAR-98
--------------------------------------------------------------------------------
4100 Fire Alarm System GENERAL
Simplex Time Recorder Co. INFO
Node Number: 1
System Type: 4100+
Job Filename : 2796
Job Title : XYZ BUILDING
Order Number :
Customer :
Customer Contact :
Contractor :
Salesperson :
Branch Number :
Branch Location :
Programmed by :
Agency Approval : NONE
NFPA Standard : NONE
Standby Generator? : NO
Hours of Standby Battery :
Comments :
:
Job Rev : 6
Built Rev : 6
Built Date : 17-Mar-98 15:22
Current As Built
------- --------
Programmer Rev : 7.03 7.03
System Defaults Rev : 79 79
Database (DBF) Format : 80 80
CFIG Format : 0 0
Table 5
GENERAL INFORMATION REPORT