195
SJ63 AJ+, SJ63 AJ 229043AAA
Section 5 – Procedures
5.1 General
The following information is provided to assist you in
the use and application of servicing and maintenance
procedures contained in this chapter.
NOTE
The illustrations shown in this manual are for
instructional purposes only. The models and
components shown may appear somewhat
different from those on your actual MEWP.
5.1-1 Safety and Workmanship
Your safety, and that of others, is the first
consideration when engaging in the maintenance of
equipment. Always be conscious of weight. Never
attempt to move heavy parts without the aid of a
mechanical device. Do not allow heavy objects to rest
in an unstable position. When raising a portion of the
equipment, ensure that adequate support is provided.
Before performing routine maintenance underneath
the riser, support it using a suitably rated lifting device
(refer to Figure 01), or cylinder chocks on both riser
cylinders. Contact Skyjack Parts to order chocks.
WARNING
Remove all material and personnel from the
platform while using the maintenance support(s).
Unless specifically noted otherwise, before beginning
any procedure:
1. Park the MEWP on a firm, level surface.
2. Retract and lower the boom, riser, and platform
until the MEWP is in the stowed position.
3. Turn the engine off.
4. Pull out the emergency stop buttons on the
base controls and on the platform controls.
5. Turn the battery disconnect switch to the off
position .
After completing any procedure which involves
modifying, adjusting, or replacing any hydraulic or
electrical components, perform all of the function tests
given in your unit’s Operating Manual.
WARNING
Make sure you maintain three points of contact
when mounting and dismounting the platform.
WARNING
Do not operate any platform controls without the
proper fall protection secured to the designated
location in the platform. Failure to do so could
result in death or serious injury!
WARNING
Make sure there are no people or obstructions in
the test area, and there is sufficient space for the
boom and drive functions required for the given
procedures.
38 700 N
8,700 lbf
Figure 01 Support location
To order go to Discount-Equipment.com
To Next Page
Loading...
Need help?
General
