33
SJ63 AJ+, SJ63 AJ 229043AAA
Function Tests Section 1 – Scheduled Maintenance
1.7 Function Tests
Function tests are designed to discover any
malfunctions before a MEWP is put into service. The
operator must understand and follow the step-by-step
instructions to test all MEWP functions.
IMPORTANT
Never use a malfunctioning MEWP. If malfunctions are
discovered, the MEWP must be tagged and placed
out of service. Repairs to a MEWP may only be made
by a qualified service technician.
▪
After repairs are completed, the operator must
perform a pre-operation inspection and a series
of function tests again before putting the MEWP
into service.
▪
Prior to performing the function tests, be sure
to read and understand the “Start Operation”
section of the operating manual.
▪
For function tests that are to be performed,
please refer to the operating manual that
corresponds to the correct serial number.
Found there are detailed instructions for which
tests to perform, as well as how to properly and
successfully perform them.
NOTE
The all-function motion alarm should sound while
operating any boom and drive function.
To order go to Discount-Equipment.com
To Next Page
Loading...
Need help?
General
