210
SJ63 AJ+, SJ63 AJ229043AAA
Section 5 – Procedures Platform
Pin 24 - Battery negative. Wire 02.
Pin 25 - Battery negative. Wire 02.
Pin 26 - Battery negative. Wire 02.
Pin 27 - Accelerator input. Wire D from drive joystick controller.
Neutral position= 4.2 volts to 4.8 volts.
Forward function= 4.9 volts to 8.5 volts.
Reverse function= 4.1 volts to .5 volts.
Test between pin 27 and 02 wire.
Pin 28 - Turret rotate input. Wire X from boom joystick controller.
Neutral position= 4.2 volts to 4.8 volts.
Rotate right function= 4.9 volts to 8.5 volts.
Rotate left function= 4.1 volts to .5 volts.
Test between pin 28 and 02 wire.
Pin 29 - Boom elevation input. Wire Y from boom joystick controller.
Neutral position= 4.2 volts to 4.8 volts.
Boom up function= 4.9 volts to 8.5 volts.
Boom down function= 4.1 volts to .5 volts.
Test between pin 29 and 02 wire.
Pin 30 - Riser input. Wire R from riser joystick controller.
Neutral position= 4.2 volts to 4.8 volts.
Boom up function= 4.9 volts to 8.5 volts.
Boom down function= 4.1 volts to .5 volts.
Test between pin 30 and 02 wire.
Pin 31 - 12 volt input from LS2, LS3 and LS4 limit switches on wire 59.
12 volts= full speed. 0 volts= creep speed (one or more limit switches open).
Test between pin 31 and 02 wire.
Pin 32 - 12 volt input from angle sensor on wire 28. 12V=<5%
Test between pin 32 and 02 wire.
Pin 33 - Toggle switch boom function enable. 12 volt input from wire 20A.
Test between pin 33 and 02 wire.
Pin 34 - Forward drive selected. Proportional output on wire 16 to forward drive valve 4H-16.
0 volts to 5.7 volts depending on joystick position. Threshold= 1.2 volts.
Test between pin 34 and 02 wire while operating forward drive.
Pin 35 - Turret rotate right selected. Proportional output on wire 33 to turret rotate right valve 5H-33.
0 volts to 6.0 volts depending on position of joystick. Threshold= 3.5 volts.
Test between pin 10 and 02 wire while operating turret rotate right.
To order go to Discount-Equipment.com
To Next Page
Loading...
Need help?
General
