Snap-On VERUS - Creating a Favorites List

77
Guided Component Test Operations Vehicle Identification
Power User Tests
The Power User Tests option gives you quick access to a pre-configured meter for conducting a
number of control system tests. Tests are available with or without on-screen help. Help typically
provides a description of the test along with expected results and a link to the pre-set meter.
How To
The How To option provides a list of available on-screen instructions for performing tasks. Scroll
to view the entire list. Typical topics include:
• 10-Minute Battery Drain Class—covers battery draw basics.
• 10-Minute Electronic Class—provides brief instruction in basic electronics and circuit
connections.
• 10-Minute High Intensity Discharge Lighting Class—provides brief instruction on high-
intensity lighting system basics.
• 10-Minute Lin Bus Class—provides brief instruction on LIN BUS systems.
• 15-Hybrid Vehicle CLASS—provides a brief overview of hybrid vehicle systems.
• 15-Minute Ignition Class—provides an introduction to basic ignition testing.
• 15-Minute Mapped Cooling System Class—provides a basic system overview.
• 15-Minute Tyre Pressure Monitoring System Class—provides a basic system overview.
• 15-Minute Voltage Drop Diagnosis Class—covers performing voltage drop tests and using
the results to diagnose circuit failures.
• 15-Minute Lin Bus Class—provides brief instruction on LIN BUS systems.
• Illustrated Terms & Definitions—provides definitions of terms, drawings and tips associated
with g
uided component testing.
• No-start Basics—provides a guideline for diagnosing a no-start condition.
• O2 Sensor & Feedback System Analysis—displays the guided component test meter in the
“live” graphing mode with O2S test tips to help you understand the fundamental concepts of
O2S diagnostics.
• Test Tips—gives on-screen instructions for performing specific guided component tests along
with drawings and tips.
• 20-minute Current Ramp Classes—provides an introduction to current ramp testing.
7.1.2 Creating a Favorites List
Once a Guided Component Test database is loaded, a list of manufacturers displays. This list is
often long and includes makes that are not frequently used. A toolbar at the top of the screen
allows you to custom configure the manufacturer list to display only the makes you frequently
service.