209
Decommissioning
NOTICE!
• The above steps for disconnecting cables apply to both the BMS and series box.
Disassembling X3-Matebox G2
Step 19: Measure the ports of the X3-Matebox G2 with a multimeter and make sure the
voltage is 0V.
Step 20: Make sure the four breakers inside the matebox are off. Loosen the swivel nuts
and then disassemble cables of the device.
1
1
2
2
Figure 12-16 Disassembling EPS(INV) and Grid(INV) cables
1
1
2
2
Figure 12-17 Disassembling Grid and Load cables
Step 21: Disassemble the Meter/CT cable in the X3-Matebox G2.
To Next Page
Loading...
